Heat pump faults, drum belts, sensors and condenser units repaired so clothes dry in a single cycle again.
About this service
When a dryer needs two cycles to do one load, the cause is usually restricted airflow or a heat pump that is no longer holding pressure. Both are measurable, so we test rather than assume. Condenser units and filters are cleaned as part of every visit, since a blocked condenser is often the whole problem.
Combined wash and dry units serviced end to end, from drum bearings and drain pumps to the drying circuit that stops clothes coming out damp.
Door seals, drum bearings and spin faults corrected, with vibration and levelling checked before the machine goes back.
Lid switches, pulsators, gearboxes and water inlet valves replaced to bring back a full, balanced wash.